The importance of vacuum pump maintenance for vacuum impregnation
OurDongguan Huiyue Technology automatic vacuum impregnation machine iscontrolled by PLC. The controller can store 0-3000 products, set theparameters well, and only need one (start) button to complete theimpregnation of the series products. Below, Ms. Hui Yue Li reminded everyone of the importance of vacuum pump vacuum pump maintenance.
1. The oil must be checked daily. When the pump is running, the oillevel should not be lower than 1/2 of the oil mirror. If it is lowerthan the 1/2 mark of the oil mirror, it should be refueled to about 2/3of the oil mirror.
2. Transformer Automatic Taping Machine The new pump must be changed oil when it is working 100H. The oil change should be based on the working conditions. Change oil every 100-150 working hours. If the working time is less than 500H, change the oil at least half a year. If there is pollution, it will change oil more frequently. Whenchanging the oil, the pump must be stopped and the air inlet should beopen to the atmosphere. In addition, the pump body should be hot. Drainthe oil from the drain plug. When the oil stops flowing, turn on thedrain plug and start the vacuum pump again for a few seconds. Thenunscrew the drain plug to drain the remaining oil. Tighten the drain plug and inject new oil from the filler port (wasteoil should be disposed of in accordance with environmental regulations)
3. Lubricating oil for vacuum pump should meet the requirements of DIN51506VC. This machine uses CG68-100 special vacuum pump oil. The machine's oil injection amount is 0.5L.
4. A contaminated screening program will result in an increase in motor output power. When an oil mist occurs at the exhaust port while the pump is operating, the exhaust screening procedure must be reversed. Remove the venting cap and get the venting checker spring and take out the venting screening program. (A new seal should be used when installing a new exhaust screening program)
HUIYUECNautomation main product series: transformer magnetic core automaticwinding machine, automatic tape machine, automatic vacuum impregnationmachine, automatic flip soldering machine, and so on,Products are widely used in high and low frequency transformers, inductors, ballasts and motor manufacturers.Transformer manufacturers prefer a one-stop solution.