How to install and debug the automatic rubber laminating machine?

2018-11-07 08:12:59 HUIYUECN 2

Our DongguanHuiyue Technology HY-B02 automatic rubberizing machine adapts to a widerange, can pack high frequency transformer, heat sink, charger plug,data cable USB and so on. In terms of installationand debugging, it is very simple. The telephone training of theemployees can be completed. The following is a brief introduction by HuiYue Xiaobian.

1. According to the heightof the product, adjust the height of the tape table or adjust the heightof the turntable and the product of the clip at the same time, so thatthe tape and the rubber tape of the product are highly sturdy, and themechanism can be locked.

2. Adjust the tension and distance of the tape, and adjust the resistance Automatic WINDING MACHINE by using the spring on the tape table.

3. Plug in the power and press the power switch to energize the machine.

4. Set the number of laps required for the product according to the product process requirements.

5,the product is placed on the holder, and the tape head is attached tothe product encapsulation, and the start switch is connected to carryout the package work.

HUIYUECNautomation main product series: transformer magnetic core automaticwinding machine, automatic tape machine, automatic vacuum impregnationmachine, automatic flip soldering machine, and so on,Products are widely used in high and low frequency transformers, inductors, ballasts and motor manufacturers.Transformer manufacturers prefer a one-stop solution.