Fully automatic impregnation machine can basically configure
The power supply of the automatic impregnation machine is AC 380V 3-phase 4-wire 50Hz. The main part of the whole machine adopts A3 material, and the surface is sprayed with green vertical paint. What are the configurations of the automatic impregnation machine? The following is introduced by Dongguan Juke Industrial Xiaobian to introduce the Automatic Vacuum Impregnation Machine.
1. Each tank is independently equipped with a heated liquid storage tank
It is heated by stainless steel heating tube, and the intelligent temperature control table controls the heating temperature. It can accurately control the required temperature. The outer layer of the liquid storage barrel is insulated with aluminum silicate insulation cotton, so that the heat loss is small and the energy consumption can be reduced.
2. With liquid filtration gas, two liquid filters are arranged at the junction of the impregnation machine and the liquid inlet pipe of the liquid storage tank. The liquid will mix with a small amount of the mixture during the impregnation process, so a liquid filter is provided in the inlet pipe to make all When the liquid enters the impregnation machine, it needs to be filtered by the filter and then enters into the impregnation machine to improve the liquid dryness, thereby improving the impregnation quality of the product. The filter structure is assembled and can be periodically disassembled and cleaned, and used repeatedly;
3. One vacuum storage tank is provided, and two impregnation tanks share one vacuum storage tank. Increasing the vacuum storage tank can increase the pumping speed: the temperature in the gas storage tank can be maintained between 0 and 10 degrees, which can be reduced. The high temperature gas inside the impregnation machine enters the vacuum pump to improve the service life of the vacuum pump. When the vacuum storage tank is not installed, a large amount of water vapor or a small amount of liquid following the gas is directly sucked into the vacuum pump during the vacuuming. When the vacuum oil is mixed together, the service life and vacuum degree of the vacuum pump are lowered, and this phenomenon can be effectively ensured after the vacuum filter is added;
4. One set of individual distribution boxes per tank, using manual control to complete the production process and mechanical opening operation
If you need to purchase or want to know more about the automatic impregnation machine, please call us for consultation! ! !
HUIYUECNautomation main product series: transformer magnetic core automaticwinding machine, automatic tape machine, automatic vacuum impregnationmachine, automatic flip soldering machine, and so on,Products are widely used in high and low frequency transformers, inductors, ballasts and motor manufacturers.Transformer manufacturers prefer a one-stop solution.