Different windings of CNC winding machines have different requirements

2018-12-25 14:12:15 HUIYUECN 0
Different windings of CNC winding machines have different requirements

Different windings of CNC winding machines have different requirements

The CNC winding machine can be wound around copper wire or round enameled wire and flat wire. The wire diameter is the most standard in the range of 1.0mm. What are the different requirements for CNC wire winding machines for different wires?

The importance of the above points around the different wires during the winding process using CNC winding is not the same. CNC Winding Machine Just take the copper wire. Round enameled wire. When setting device parameters. The starting point, width, and wire diameter requirements are relatively high. For example, if the wire diameter is set incorrectly, the winding machine will cause an accumulated error. As the error increases, the stacking line or the cable is not tight.

In order to avoid this situation, our company's Huiyue CNC winding machine series has manual deviation compensation function. Speed is secondary. The flat line is the opposite. The speed of the flat wire is determined to be slow. The wire rod diameter is highly demanding on the round wire and the flat wire is required to be low. The tension and the spindle concentricity of the winding machine are both high. The sculpturality of the skeleton is very important for the garden line. Flat wire requirements are lower. The accuracy of the cable arranging mechanism is the key to the winding machine of the slab. If the accuracy of the arranging mechanism is not high, the winding machine is the smashed scrap iron. The accuracy of the cable mechanism is the key to any wire. The position of the outlet is not high for the two. As long as the distance between the guide wheel of the cable mechanism and the skeleton is ensured, the CNC winding machine will only wrap around different skeletons. (mainly the difference between a circle and a square)

Follow Us

HUIYUECNautomation main product series: transformer magnetic core automaticwinding machine, automatic tape machine, automatic vacuum impregnationmachine, automatic flip soldering machine, and so on,Products are widely used in high and low frequency transformers, inductors, ballasts and motor manufacturers.Transformer manufacturers prefer a one-stop solution.

New Products

Contact Details

  • No. 53, Shangnan Road, Shangjiao Community, Chang'an Town, Dongguan City, Guangdong Province, China
  • +86-769-89870552