The high-frequency transformer has a winding machine in the manufacturing process. The requirements for the winding are also relatively high, and the number of turns and the width of the winding are required to meet the standard requirements. In the winding process, Transformer Core Automatic Winding Machine the horizontal bar Huiyue HY-R06 CNC side single-axis automatic winding machine can be operated. The following is a brief introduction to the high-frequency transformer winding process details from Huiyue Technology.
1, determine the parameters of BOBBIN
2, all winding requirements are flat and do not overlap as the principle
3, a single set of windings can be a monochromatic line, the double set of windings must be dip-lined with two-color lines or open lines to avoid pinning.
4, across the line must be taped to isolate
5, dredging completely evenly
6, tight winding line is evenly close
7. Keep the safety distance between the two sides of the coil and the edge of the winding groove A, B
8. The length of the casing must be sufficient. The end of the stern extends into the safety tape of the bobbin, and the other end extends out of the BOBBIN, but not near the PIN.
9. The outermost tape is cut on the core joint surface, and the cut surface must be covered by the iron core.
10. The edge of the tape is flush with the winding groove, the tape is not skewed, and it is not broken and not damaged.
11. Tape must be applied under the line to keep the crossing line insulated from the bottom coil.
HUIYUECNautomation main product series: transformer magnetic core automaticwinding machine, automatic tape machine, automatic vacuum impregnationmachine, automatic flip soldering machine, and so on,Products are widely used in high and low frequency transformers, inductors, ballasts and motor manufacturers.Transformer manufacturers prefer a one-stop solution.