Explain how to evacuate the vacuum impregnator?
Our Dongguan Huiyue Technology semi-automatic vacuum impregnation machine will process the production of impregnated objects into the cylinder, close the cylinder head and lock it by the cylinder head locking device. Vacuuming the negative pressure and maintaining the simmering time; pressurizing the liquid in the liquid storage tank into the cylinder under the action of the atmosphere, and closing the liquid inlet pipe after the liquid reaches a predetermined height. Pay attention to pressure and pressure.
Exhaust (exhale and vent), open (suck) the exhalation nozzle to exhale the air in the cylinder. The pressure is equal to the outside of the cylinder. Pressurize and drain the liquid, and pressurize all the liquid in the cylinder by adding positive pressure. At this time, the liquid discharge port is closed.
Finally, vent, dry, and take out. The coil is continuously completed in the same immersion paint cylinder, white blank pre-baking - vacuum low temperature dehumidification - vacuum (pressure) impregnation - paint lacquer lacquer - cylinder bottom cleaning - low temperature drying - vacuum assisted recovery solvent - high temperature curing, etc. The whole process.
The entire treatment cycle of the vacuum impregnation machine has been shortened from the past tens of hours to 6-8 hours, greatly reducing the labor intensity of workers, improving the working environment, saving a large amount of insulating varnish, and saving electricity and saving insulating varnish. Can recover all the investment.
HUIYUECNautomation main product series: transformer magnetic core automaticwinding machine, automatic tape machine, automatic vacuum impregnationmachine, automatic flip soldering machine, and so on,Products are widely used in high and low frequency transformers, inductors, ballasts and motor manufacturers.Transformer manufacturers prefer a one-stop solution.