Automatic single cylinder vacuum impregnation machine manual operation setting

Automatic single cylinder vacuum impregnation machine manual operation setting

Our Dongguan Huiyue HY-Z02 automatic single-cylinder vacuum impregnation machine is controlled by single-chip microcomputer. It has automatic control function and manual control function. If you want to use manual control, you must first enter the manual control mode. What? Below is a small editor of Huiyue to introduce you to you.
1. Under the initial screen, vacuum impregnation machine click to open the system.
2. In this interface, click on the parameter setting to automatically enter the parameter setting interface.
       
3, parameter setting: closing time (seconds), vacuum 1 time (seconds), rising 1 stroke (mm), soaking 1 time (seconds), vacuum 2 time (seconds), rising 2 strokes (mm), soaking 2 times (seconds), exhaust 1 time (seconds), down position (mm), vacuum 3, time (seconds), drip drying time (seconds), exhaust 2 time (seconds), bubble control exhaust (seconds), row Air interval (seconds), number of exhausts (times), opening time (seconds), lifting speed (minutes/turns), alarm time (seconds), etc.
   

4, the parameters set here can enter the main page, press F1, enter the recipe value, you can save the current recipe to the input value.