Fully automatic impregnator running program

2018-12-01 10:15:35 HUIYUECN 0

Our Dongguan Huiyue Technology Automatic Immersion Machine has two automatic and two-cylinder impregnation machines. The single cylinder is controlled by CNC single-chip controller. The double cylinder is controlled by PLC controller, which can control two cylinders at the same time. What is the main running program? Below is a brief introduction by Huiyue Technology to introduce you to you.
1.Automatic Vacuum Impregnation Machine Turn on the three-phase main power supply, open the panel power switch, open the intake valve, automatically open the impregnation cover, and manually put the impregnated material.

    2. Press Start, close the impregnation tank cover, close the intake valve, and open the suction valve. Set the required parameters in the control interface.

    3. If you need to observe the specific conditions of the cylinder, you can observe it from the viewing window.

    4. The machine will run automatically according to the setting program, and manual operation will not be possible.

HUIYUECNautomation main product series: transformer magnetic core automaticwinding machine, automatic tape machine, automatic vacuum impregnationmachine, automatic flip soldering machine, and so on,Products are widely used in high and low frequency transformers, inductors, ballasts and motor manufacturers.Transformer manufacturers prefer a one-stop solution.