How is the nozzle and nozzle of the automatic casing machine positioned?

How is the nozzle and nozzle of the automatic casing machine positioned?

OurHuiyue technology automatic casing machine is micro-computer control,full Chinese CNC single-chip control display, easy to operate; casingsize can be adjusted for most of the casing transformer production; thisautomatic casing machine with CNC Convenient, quick to get started, quality assurance, and improved production efficiency. How is the nozzle and nozzle of the automatic casing machine positioned? The following is a brief introduction by Hui Yue Xiaobian.
1, the general machine uses a nozzle, the nozzle can be mobilized up and down structure. The nozzle of the nozzle cannot be positioned front and rear. Wheninstalling the nozzle and nozzle, it is necessary to rely on experienceto judge the distance from the tip of the nozzle to the pressure cutter.

Reason:The single-acting structure of the compactautomatic coil taping machine  is adopted, and the fixedsurface of the load surface is not adjustable. When the wire type andthe pipe type are changed, the pipe diameter and the wire diameter form atolerance with respect to the horizontal line of the load surface withthe increase of the diameter. Itis also increasing, so it is necessary to adjust the relative height ofthe nozzle and nozzle with the carrying surface, so that the machinecan smoothly pipe and thread. (Do not adjust the upper and lower, even the very close line and tube can not be used)


2,the fool machine adopts the nozzle, the nozzle fixed structure, and theinstallation position of the nozzle at the mouth of the wire, to ensurethe fixed distance of the distance between the nozzle and the nozzle tothe cutting knife after the installation is completed (nozzle 0.3mmline) Mouth 0.1mm)

Reason:The double-acting structure of the clamp is used to ensure that thefixed values of the relative heights of the nozzle and nozzle and theV-shaped load surface are unchanged after the replacement of the model.