Ready before using the fully automatic vacuum impregnation machine
Our Huiyue technology automatic vacuum impregnation machine is suitable for electronic manufacturers, transformer impregnation. The main machine vacuum impregnation machine is controlled by the PLC controller, which automatically switches the cover and automatically vacuums the second time, saving time and effort, environmental protection and energy saving, and can realize single and multi-machine operation. Take a few steps before using it to avoid unnecessary accidents.
1. Check if the power supply and air supply are normal.
2, check the recycling bucket breathing valve, should be kept open
3. Check the bottom of the impregnation pool and close it.
4. When the above are normal, press the power start switch
5. After the screen display is normal, check the vacuuming time, positive pressure time, thinner time, viscosity value, whether the setting is normal, and whether the emergency stop switch is restored.
6. Click on the on-screen inverter motor and stirring motor to turn it on.
Select the rotor on the viscometer, the speed, press "OK" again, then press "Open"
HUIYUECNautomation main product series: transformer magnetic core automaticwinding machine, automatic tape machine, automatic vacuum impregnationmachine, automatic flip soldering machine, and so on,Products are widely used in high and low frequency transformers, inductors, ballasts and motor manufacturers.Transformer manufacturers prefer a one-stop solution.